Toggle menu
(262) 763-5100
  • 0
  • HANGAR SALE
  • Aero Commander Models
  • Aeronca Models
  • American Champion Models
  • Beechcraft Models
  • Cessna Models
  • Cirrus Design
  • Luscomb Models
  • Maule Aircraft Models
  • Piper Models
  • Mooney Aircraft Models
  • Robinson Helicopter Models
  • Rockwell Commander 112 / 114 Models
  • Taylorcraft Models
  • Van's Aircraft / RV Models
  • Brake and Wheel Parts
  • Electronics
  • Hardware
  • Lighting
  • Maintenance Supplies
  • Oil, Oil Filters and Spark Plugs
  • Pilot Supplies
  • Wheel Bearings
  • The Aviator Collection
  • Shop by Brand
  • View all Brands
  • RMD / K2U Wing Tip With Landing Light Lens.

    • Replacement Lenses, PA-28, PA-32 RMD / K2U Wing Tips With Landing Lights. RD-6001

    $196.00
    Write a Review
    SKU:
    RD-6001
    Adding to cart… category.add_cart_announcement

    Product Description

      

          These are replacement lenses for the RMD / K2U wing tips with landing lights. These lenses will not fit other brands of wing tips.  If you have any questions regarding what kind of wing tips you have please feel free to send us a picture.

          Drill bits specially angled for drilling plastic are available here Drill Bits

    Part Number:

    RD-6001-L(S)
    RD-6001-R(S)   

    Approval Basis:

    FAA-PMA Approved

    Replaces:

    RMD / K2U Wing Tip Landing Light Lenses

    Aircraft Eligibility:

    PA-28-151, PA-28-161, PA-28-181, PA-28-201T, PA-28-236, PA-28R-201, PA-28R-201T, PA-28RT-201T.

    PA-32-301, PA-32-301T, PA-32R-301, PA-32R-301T.

    Typical Lead Time:

    Stock

       

    Finish:

    Clear

    Specifications:

     

    Notes:

     

     

     

    Product Videos

    Custom Field

    Product Reviews

    Write a Review

    1 Review Hide Reviews Show Reviews

    • 2
      Worked but very poorly made

      Posted by Brent Reddick on 2nd Feb 2017

      I literally thought I had been sent the wrong lenses when I pulled these out the box. The amount of shaping and trimming that these require is ridiculous. I had to trim 1/4 to 1/2" off of every side. The acute angle on the outer edge is way too sharp / small. I did not use a heat gun to open the angle as I was afraid it may harm the lens and make it brittle. After several hours of trimming and fitting I ended up with an *acceptable* finished product but still lacking a great fit. From looking at pictures of other people's replacement lenses I actually did a really nice job getting mine like I did. The lenses are nice looking otherwise. For the $ I expect a MUCH better fit out of the box! There is absolutely NO way you could put them on any RMD tip without significant trimming.